You are here... Help & Advice Device Configurations Linksys PAP2 Adaptor

Linksys PAP2 Adaptor
Linksys PAP2 configuration
  1. Connect the ATA to your phone using a telephone cable. Use the phone port marked line 1 on the back of the ATA.
  2. Connect the ATA to your router using the Ethernet network cable, make sure the ATA is connected to a power source.
    Learn how to connet a PAP 2
  3. Pick up the phone receiver and dial ****, at the voice prompt dial 110# you will then hear the device's IP address, take note of this address.
  4. Enter the IP address noted in step 3 above in the web browser's address field. Then press the Enter key.

    Linksys ATA configuration

    Linksys SIP configuration

  5. If a small window appears asking you for a Username and Password:

    Enter admin (the default) in the Username field, then enter admin (the default) in the Password field. (Later you should set a new password using the Administration tab's Management screen. This will help secure access to the web-based utility).

    Then Click the Log In / OK button.

  6. The router's web-based utility will appear with the Basic Setup screen. Click on the Line 1 menu button to bring you to the next screen.

    Linksys PAP2
  7. In the user settings screen fill out the highlighted fields referring to the information provided on the Welcome Sheet / Email which you received from Blueface.

    Linksys PAP2 Blueface
  8. On the same page scroll down to the bottom and change the highlighted drop-down menus to no . Then click the Save Settings button.

    PAP2 Blueface
  9. When you are returned to the Basic Setup screen. Click on the User 1 menu button to bring you to the next screen.

    Linksys PAP
  10. Scroll down to the bottom of the page and change the value in the highlighted field to 0 . Finally click the Save Settings Button to complete the configuration.

    Linksys
Back to Top